Gap free machine composed Meghalaya Pine
based blockboard substrate are fully seasoned and
bonded with MR grade plywood on both sides by
using face veneers of thickness 0.4mm and core of
thickness 2.5mm from matured timber. These solid
flushdoor shutters are designed for indoor
applications without any direct contact with water
and sunrays

THICKNESS: 32 mm & 35 mm
  • 78x26, 80x26, 78x31, 80x31, 78x36, 80x36, 78x38, 80x38

Product Description


Nipponply flushdoor shutters are widely used for
residential and commercial complexes, schools,
restaurants, hotels, offices, cinema halls, apartments


  • Decorative veneer face
  • Direct Polish/Duco paint can be done.


  • Zero Gap
  • Eco Friendly
  • 100% Seasoned & Virgin Meghalaya Pine Wood
  • Weather Resistant
  • Acoustical Effectiveness
  • Low Emission

Technical Specification

1 Dimension Length, Width -+5 mmThickness-+ 1mm Within Limits
2 Squareness Deviation not more than 1mm on a length of 500 mm Deviation below 1mm
3 General Flatness Twist, cupping, warping not to exceed 6 mm
4 Local Planeness Depth of deviation at any point to be less than D.5 mm Within Limits
5 Impact Indentation Test Depth of Indention not to exœdd 02 mm Within Limit
6 A dhesionto Plies The deflection at the maximum load shall not be more than 1/3D of length and 1/15 of width and the residual deflection should not be more than 1/10 Satisfactory
7 Edge Loading Test Deflection of edge with max. to be lessthan 5 mm Within Limit
8 Shock Resistance Test No visible defect aftertest No Visible Damage
9 Buckling Test Initial Deflection - < 50 mm Residual Deflection - < 5 mm Within Limit
10 SlammingTest No visible damage aftertest No Visible Damage
11 Misuse Test No deformation aftertest No deformation
12 Varying Humidity Test No visible warping, twisting or de-lamination No such defect observed
13 End Immersion Test End Immersion Test No de-lamination
14 Knife Test Minimum Pass Standard Excellent
15 Glue Adhesion Test No de-lamination No de-lamination
16 Screw Withdrawal Test Load to withdraw the screw shall not be less than 1000 N 1250 N